Correct steps

Troubleshooting: First, observe whether there are any obvious abnormalities in the electrical ready board, such as smoking or burning marks on the wires, and whether the electrical equipment is damaged or short circuited. If obvious fault points are found, the fault must be dealt with first and cannot be reset directly, otherwise it may cause more serious safety accidents.

Disconnect relevant electrical loads: To ensure safety, before resetting, try to disconnect the power supply of the electrical equipment controlled by the electrical ready board as much as possible to reduce the current surge during power on and minimize risks.

Confirm reset conditions: Ensure personal safety, stand on dry insulation, wear protective equipment such as insulated gloves. Check the surrounding environment of the electrical ready board to ensure that there are no hazardous factors such as water accumulation and humidity.

Perform reset operation: Find the leakage protector or circuit breaker in the electrical ready board, usually with a clear reset button or operating handle. For the leakage protector, press the reset button, if it can bounce up normally, then close the switch; For circuit breakers, simply turn the operating handle upwards to the closed position.

Gradually restore power supply: After a successful reset, do not immediately turn on all appliances. Instead, turn on some important appliances first, observe for a period of time, confirm that there are no abnormalities, and then gradually turn on other appliances.

precautions

Safety first: During the operation process, it is necessary to strictly comply with electrical safety regulations to avoid electric shock accidents. If you are not familiar with electrical knowledge, do not operate on your own and contact a professional electrician.

Record faults: Record the time, frequency, and electricity usage at the time of tripping to facilitate subsequent troubleshooting and maintenance.

Regular inspection: Regularly inspect and maintain rural lighting electrical ready boards and circuits, promptly identify and address potential safety hazards, and ensure electrical safety.