During peak electricity consumption periods, there is a significant increase in electricity demand. As a key hub for circuit distribution and control, the load balancing and safe operation of lighting electrical ready boards are crucial.

Load balancing is key

The uneven load of each circuit in the lighting electrical ready board can cause some lines to overload, while others are not fully utilized. Overloaded circuits can generate heat due to excessive current, accelerate insulation aging, and increase the risk of short circuits and fires. Before the peak electricity consumption, it is necessary to check the load situation of each circuit and allocate electrical equipment reasonably. For example, dispersing high-power appliances in different circuits to avoid using multiple high-power appliances in the same circuit, such as air conditioners, electric water heaters, etc., should be staggered as much as possible to ensure that the loads of each circuit are relatively balanced and to ensure the stable operation of the electrical ready board.

Security checks cannot be omitted

Regularly inspect the appearance and internal condition of the electrical ready board. Check whether the box is damaged or deformed, whether the door lock is intact, and prevent rainwater and dust from entering. Check whether the internal wiring is loose or aged, and if so, tighten or replace it in a timely manner. At the same time, it is necessary to ensure good ventilation around the electrical ready board, no accumulation of debris, and avoid affecting heat dissipation.

Remember to use electricity safely

Non professionals should not open the electrical ready board at will to avoid electric shock accidents. If any odor, abnormal noise or smoke is found in the electrical ready board, the power should be immediately cut off and a professional electrician should be contacted for maintenance. In addition, do not place flammable and explosive materials near the electrical ready board to create a safe environment.

During peak electricity consumption periods, only by balancing the load of lighting electrical ready boards, strengthening safety inspections, and keeping in mind safety knowledge can we ensure the electrical safety of households and businesses, and allow everyone to safely pass through peak electricity consumption periods.