What Should Be Done For The Installation Holes Of The Lighting Electrical Ready Board In Rural Africa?
In rural Africa, there is high temperature and humidity, large temperature difference between day and night, and salt spray and sand in some areas. The installation holes of electrical ready boards are prone to corrosion, and it is necessary to do a good job in hole formation, edge protection, assembly sealing, and anti-corrosion matching treatment. During processing, precision punching or drilling should be carried out first to remove burrs and sharp edges from the hole opening. The chamfer of the hole opening should be smooth to avoid coating stress cracking; After forming, perform phosphating pre-treatment to ensure that the inner walls and edges of the holes are fully degreased and rust removed. Before spraying the entire electrical Ready Board Box body, the edges of the installation holes should be carefully covered or pre coated with zinc rich primer to compensate for the thin coating on the inner wall of the holes during spraying and prevent bare iron exposure. 304/316 stainless steel bolts, flat washers, and EPDM weather resistant rubber sealing gaskets are selected for assembly. The gaskets are tightly attached to the outer wall of the box to block rainwater and condensation from seeping into the gaps of the holes through the screw, avoiding galvanic corrosion caused by direct contact between different metals. Add isolation bushings during installation to reserve ventilation gaps between the box and the wall or pole body, preventing water and mud accumulation on the contact area. After completion, the outer gasket of the hole position and the damaged coating position of the hole opening shall be coated with weather resistant and anti-corrosion topcoat to form a continuous protective layer. At the same time, reasonable tolerances should be reserved for the aperture to prevent assembly scratches and coating peeling caused by the aperture becoming smaller after spraying. The whole set of treatment can significantly improve the tolerance to salt spray and humid and hot environments, reduce hole rust penetration, bolt jamming, and box loosening faults, and adapt to local low maintenance and operation conditions.


