Correct steps

Cut off power: First confirm the position of the main switch of the electrical ready board, pull it to "OFF" or turn it down to the disconnected state, ensure that there is no current passing through the operating environment, and guarantee your own safety.

Troubleshooting: Observe the status of each switch in the electrical ready board and check for any abnormalities such as burnt wires or smoking of electrical equipment. If obvious fault points are found, such as short-circuit electrical appliances, disconnect their connecting wires first; If there are no obvious faults, each branch electrical equipment can be checked one by one to determine if there is an overload situation.

Reset operation: After confirming that the fault has been resolved, turn the tripped switch upwards to the "ON" position to complete the reset. If it trips again immediately after resetting, it indicates that the fault has not been completely resolved and needs to be re investigated.

Restore power supply: After resetting the main switch, observe the operation of the electrical equipment and confirm that there are no abnormalities before using it normally.

precautions

Safety first: Keep hands dry during operation, avoid contact with damp objects, and prevent electric shock. If you have insufficient understanding of electrical knowledge, do not operate on your own and contact a professional electrician in a timely manner.

Avoid frequent resetting: Do not frequently reset the switch without identifying the cause of the fault, as this may damage electrical equipment or cause more serious safety accidents.

Regular inspection and maintenance: Regularly inspect the rural lighting electrical ready board to check whether the circuit breaker is loose, whether the circuit is aging, etc., replace damaged parts in a timely manner, and ensure the normal operation of the electrical ready board.

Record the fault situation: After each trip, record the trip time, the electrical equipment used at that time, and other information to help investigate the cause of the fault and provide reference for professional electrician maintenance.